Prusa XL Improved Parking Plate / Head Roller Seal

Another method to seal the heads..
18
28
0
679
updated March 17, 2024

Comments

i have sanded bearings and used a few different glues simple super glue mitreapel
i can't get anything to stick to the silicone baking sheet i even bought a couple of different ones any advice ?

@Gene_48350 I used Loctite "Super glue - 3".Before being glued together, the bearings were degreased after sanding, and the Silicone strips were also degreased (IPA).The 5 assemblies I made in this way have been working perfectly for 2 months, with no peeling observed.

@Renba okay off to buy some loctite 3 i did use alcohole to degrease might be the type of silicon mat maybe i need a trip to ikea thanks for tip on the Glue

maybe not doesnt look like the glue-3 is avl in the us i found it in spain and on ebay in other countries well that sucks i found some high temp silicone tubing that had inside diameter of those bearings should get delivered tommorrow ill see if that works

@Gene_48350 a guy who did the mod on his XL glued it by applying PERMABOND POP (primer) to his piece of silicone and applied PERMABOND 105 (special cyanolycrate glue for difficult plastics) to the bearing. I hope you'll succeed...

Show all comments