Lightsaber Tsuba

If you fight with your lightsaber, use a tsuba. 

These tsubas have a 33.4 mm (basic) and a 33.8 mm opening, and fit perferctly for my TXQ Mando V2 and my TXQ Padawan E09 lightsabers. Depending you your hilt you might need to sand it a bit and/or use a tsuba dome and/or some plumbing O-rings (28mm diameter, 3mm thick) to hold it in place. 

Print is with at least 3 perimetes and 20% infill (I found gyroid to work best), so it can take a beating. I did print in PETG but PLA should work as well. Whatever you use, do wear eye protection when duelling. Not only because of the 3d printed parts.