I'm a pretty bad FPV pilot. As shown by the fact my poor Nazgul 5 (V1) looks like a lawn mower. I've made this little stopper to help hold the battery in place during crashes because mine kept sliding forward enough to pull the connector out. I don't fly with a go-pro camera because there's just no point in watching the train wreck again. I just held the stop in with tie-wraps, and there's a little cut out so it can fit up against the battery pad.
I printed this in TPU but I guess PLA would work.
I used a support on the print bed for the cut-away on the bottom, but no supports for the tie-wrap hole. I don't think you'd ever get them cleaned out, and the bridge is so small that TPU jumps it no problem.
The author marked this model as their own original creation. Imported from Thingiverse.