Tamping stand for 58mm bottomless portafilter

A simple tamping stand for a bottomless 58mm portafilter. My cheapo bottomless portafilter has different dimensions than my “official” Rancilio portafilter, So i needed a slightly different tamping stand for it. I designed this one and it does the job. It, too, is bottomless to keep with the theme and also reduce printing time.

Printing suggestions:

• PETG recommended.
• Print with 3 perimeters.
• Print with variable layer height, the higher the layer height the better.
• Either use 10% lightning infill, or 0% infill.

I printed with a 0.6 nozzle, but 0.4 is just as good, although a bit slower.

I've included the OpenScad file in case you want to tweak the dimensions a bit before printing.