Check out Prusa's Black Friday Deals. Only valid until December 3rd!

.480 Ruger, Head Up, Snug Snap Latch Modular Ammo Box

The Snug Snap Latch snaps into a locked state when it is pressed towards the box front and it passes over a retaining…
This is an exclusive model available only to supporters of the creator.
Your funds support the creator's further activity.
$5 /month
1
0
36
updated May 3, 2024

Description

The Snug Snap Latch snaps into a locked state when it is pressed towards the box front and it passes over a retaining tab. To open the box, pull the latch past the retaining tab and lift the box's lid. The thinness of the Snug box top allows the box bottom to be made taller, so that rimmed cartridges hang from the rim with no contact of the bullet tip with the box bottom.

Look in my Ammo Boxes Collection https://www.printables.com/social/261776-brass_ring/collections/167118 to see my ammo boxes with different latches and hinges options.

Other ammo boxes of this type can be found in my Snug Snap Latch Ammo Boxes Collection https://www.printables.com/social/261776-brass_ring/collections/532975 and https://www.thingiverse.com/brass_ring/collections/37492825/things.

This cartridge box is printed as separate parts that are printed in orientations chosen to maximize strength and then snapped together.

The box halves require moderate infill (10%-20%) and must be printed with supports. I prefer to paint on supports under the flat sections on the hinge hoops, under the curved area of the latch pins, and under the front retaining tab of the latch catch. I printed with 0.20 layer height in PETG and PLA. Make sure that you clear all support material to ensure proper function.

Do not use Perimeter Generator: Arachne on the box bottoms.

Check for the latest hinges and latches in https://www.printables.com/model/187176-modular-ammo-box-common-parts or https://www.thingiverse.com/thing:5270385.

Assembly Instructions:

Slide the hinges over the hinge pivot pins of the box top with the slot in the hinge facing the box top and the locking tabs pointing down and tilted inward 45 degrees.

Pivot the hinge tabs so that they point down and place the box bottom under the box top so that the hinge fixture hoops are aligned with the hinge tabs.

Carefully, press the the hinge locking tabs into the hinger fixture hoops until they lock into place. You may need to press the hinges into place in steps to keep the hinges aligned.

Slide the latch over the box top's latch pivot pin with the slot in the latch facing the box and the latch tilted inward 45 degrees.

Category: Tool Holders & Boxes

Tags



Model origin

The author marked this model as their own original creation.

License