RepRack for NSF shelving

RepRack for NSF shelving low profile Remixed version of "RepRack" filament storage system. Uses 1/2" EMT conduit as the Rack rails of the system. Requires screws to install the clamps that retain the rack rails or use these press on endcaps I designed this to work with my Trinity wire shelving. This fits shelving with 1" diameter support poles, using this clip if you don't have any spares. This is the first design and meant to be used on top of the wire racks, either for storage or as spool feeders. Prints without supports, 3 walls 20% infill, minimum.

RepRack for NSF shelving heavy duty

I designed this after testing the low profile model. This fits shelving with 1" diameter support poles, using this clip if you don't have any spares. The Hanger slides in like it would with a wall cleat.

This model is more sturdy and can be floated above the wire rack shelf. This will allow you to utilize more of the dead space on the rack at the top. Or even create floating spools in-between the wire shelves. This requires supports to print properly, 3 walls 20% infill, min.

This is designed to work with NSF shelving with 1" diameter support poles.

2 versions, low profile and regular.

Get the other parts from the original