Christmas Light / Patio Light / Bistro Light Hook For Block Wall

Hang Christmas or bistro-style lights along the upper edge of a block wall fence without drilling holes in the wall.   

• For block walls 4" (~100mm) to 6" (~150mm) deep, print one Front and one Rear part each.
• For block walls from 6" (~150mm) to 8" (~200mm) print one Front and one Rear XL part each.

You will need a single M4 x 6mm screw to join the two pieces together for each hook.

For internal or seasonal use, PLA is a suitable filament.   For year-round use, consider ASA or PC filaments.

Print both sections upright with the front or rear on the bed.   Supports are not required, but if your printer struggles with bridging you may encounter a small amount of aesthetic sagging inside the hook.
 
The two-piece design allows the hook to be printed on nearly any printer, including a Voron V0 or Rook MK1.
 

---

NOTICE: If you post remixes online --- Printables, Thingiverse, Cults, etc. -- you must include attribution and link back to this original design. Do not claim the original design as your own.