Enlarged Floppy Dragonfly Stand

We wanted to personalize the Floppy Dragonfly prints we were making to celebrate chartering a new Lions Club, so remixed the Dragonfly Base to add a large flat area for text.

Printed on a MK4, PETG, 0.4 Nozzle, 0.2mm layer height, input shaping on.

Note #1: 0.4 nozzle pretty much requires a bold font at least 6.5mm in height. Also, make sure your filament is nice and dry (the yellow filament wasn't, resulting in stringing).

Note #2: smaller nozzle would probably allow finer/smaller font for the text, but I didn't have time to tune that before the charter event.

Added a large flat plaque area for text.