Tapo C100 Enclosure Clamp Holder

Unable to find a holder that suited my needs, I merged two models discovered on this site for my printer's 7.9mm plastic tube frame enclosure. I made some minor adjustments to enhance its solidity. Both the clamp and the holder part are snug enough, securely keeping my C100 in place without any movement

To remove the stand from your Tapo C100, follow these instructions:

1. Locate and unscrew the two screws beneath the C100 camera.
2. Once the screws are removed, carefully detach the tight-fitting bottom cover. You may use a metal spudger (recommended) or alternatively, a screw or knife (with caution). Be mindful of the four plastic locks inside each corner.
3. Remove the rubber plug to reveal another screw. No seals are broken during this process, ensuring no warranty issues.

Printing recommendation

0.2mm or less layer height

no supports needed

15% infill is enough

PLA/PETG/ABS

Merged two models with some minor adjustments