Rose with Stem

I made this model as a Mother’s Day gift for my mom last year. It works great. The rose is a little too big for the stem, but it makes good table decoration if you lay it down. I used Jerrill's rose and added a stem, and round base to it. It was a fun challenge.

Note: I haven't tried to print the stem laying down. I printed it standing up.

Printer: Ender 3 v1

Rafts: Yes for the Stem

Support: Yes

Resolution: 0.2

Infill: 20%

After print super glue the round base (Rose_Head_2) to the rose (Rose_Head_1) and then glue the stem (Rose_Stem) in and your done.

Enjoy!

I added the stem and the base piece to allow the Rose to print standing up, but still keep the rounded look near the bottom.