MT-60 Waterproof Connector --> MTW-60 :-)

!I bought the following MT-60:

https://www.amazon.de/dp/B07P7MW4YH?psc=1&ref=ppx_yo2ov_dt_b_product_details 

They are very high quality compared to other MT-60. 

Wire: philippi h07bq-f 3x2.5

I created blind plugs for transport so that the threads and contacts are protected.
 

To assemble: 

Print all parts. Then you strip the insulation from the cable and put it through my plug. 

Then solder the cables to the MT-60. Then stick some 2K glue on the MT-60 connector and plug it in the printed part. 

Finally, pour epoxy into the rear hole on the printed part until everything is nicely filled. 

The female plug has ventilation holes. After soldering the cables and cold MT-60 putty in the front where the pins come in. You see the holes.
And only then pour it out

On the male plug with the union nut, the nut is designed to be 2% larger. The nut should therefore go over the thread of the female plug. Pressure settings for me were 0.15mm with 5 walls. After pressing on the female plug, grind a small bevel on the thread and apply Vaseline to the thread. Then test with the blind plugs and turn them up and down a few times. Then the thread should run cleanly.

If you have any questions, get in touch.