Raspberry Pi Pico Case with Reconfigurable Connector

Created this Raspberry Pi Pico case to allow interfacing with ADXL345 accelerometer via a custom cable.  My specific use case was I had previously created a cable for an ADXL345 with a pinout to interface directly with the SPI port on a BTT Manta M5P and wanted to reuse it with other printers.  The easiest path in my mind was to map the GPIO on the pico to the matching pinout on a DuPont connector, which is what this case accomplishes.

This case can easily be reconfigured as needed by switching the jumper wires on the GPIO for prototyping.
 

Cable

1x 2x4 DuPont connector

8x 10cm male-to-female jumper wires 

De-pin the male ends of the jumper wires and insert into 2x4 connector as desired.  Connect female ends to GPIO pins.