Lasko Fan Remote Holder

Remote holder for the rounded Lasko fan controller. Has nice beveled edges and some options for screwing in vs adhering to a surface.

Dimensions

The remote this was measured for is 51.25mm-58.25mm (curved, bottom to top) by 18.35mm (front to back). This model provides a 0.5mm (tight fit) on all sides of the remote.

Height is 42mm.

Printing Instructions

I used PLA+ with a 6 line brim for sturdy adhesion.

1. Print standing up, as the model lies.
2. Take it off your print bed when it's done. Boom.