E3P 13mm TPU Foot

This is a basic TPU foot that I made to raise my Ender 3 Pro up by 13mm (1/2 in). I also tested it with PLA and it does work, but it can be very snug depending on the tolerances of your machine and how well it's tuned.

Print Settings

Printer: Creality Ender 3 Pro

Rafts: No

Supports:  No

Resolution: Standard (0.2mm)

Infill: 50% Gyroid

Filament: Inland - Black - TPU

Notes:

No supports are needed, if printed on its face.

Sliced in Cura, switch the filament type to Generic TPU 95A.

Additional Settings

230/0 (YES the bed heater is set to 0)

Printer Speed:25mm/s

3 Walls

If printing in PLA, use whatever you would normally.