Closed filament cleaner for K1

Closed filament cleaner for K1 that does not need to be put on the filament, but only threaded through it (mounted on the back of the K1 directly under the filament sensor) (K1 MAX not tested) Assembly Instructions Glue the sponge to the moving parts and place it in the box so that the sponges are facing each other. Then close the lid and place under the thread sensor (The model is made so that the lid does not come off when inserting the thread, check before closing that everything is correctly installed because the lid will be difficult to open).

Slicer: Creality print Plastic: Hyper PLA Layer height: 0.20 Line wight: 0.42 Wall lines: 2 Filling: 100% Temp nozzle: 220° Temp bed: 50°+ glue(If you use a bed with a rough surface, set the temperature to 60.) Print Speed: 120.00 Infill Speed: 120.00 Outer Wall Speed: 80.00 Inner Wall Speed: 80.00 Top/Bottom Speed: 120.00 Cooling:Optional Ironing: on Support at your request. If you want to connect the cleaner to the filament box with a PTFE tube, it is better to include supports for better hole printing