Espresso Leveler

This is a multi-part object.

After opening as mulitpart object remove the “Gummi” to print the grip and the leveling surface. As they are two objects it is quite easy to use different colors. I used PETG and a steel nozzle to be as much food-safe as possible.

Then print the “Gummi” in TPU.

No fancy print settings.

• no supports
• layer hight: 0.2-0.3mm (or if you want to sand less even finer)
• 5-10% infill
• 3-5 perimeters
• 4-6 bottom top layers
• for the TPU ring you might want to print slower (depends on your setup)

The TPU ring can be slipped over the grip (it is designed quite tight.