Luffy Gear 5 - One Piece 2D

Hello!, this time I bring you the model for wall decoration to
"Luffy Gear 5" or "Luffy Fifth Gear" in 20 cm 2D.

You can print it in one piece or print it in 2 parts if it doesn't reach your printer (like my c':). You can also scale it.

Below I leave you the parameters with which I printed it but you can use yours and tell me how it went.

Enjoy printing.

Parameters

- Layer Height and Initial Layer: 0.2 mm
- Horizontal Expansion: 0.12
-Infill: 15%
- Fill Pattern: Lines
-Bed temperature: 55 °C
-Print speed: 50 mm/s (attached an image with the speeds in more detail in the carousel) It is important that in the initial layers they are of low speeds to achieve good adhesion.
-Support: No