Webcam holder for Aquila (Ender 3)

Webcam holder attached to printer frame using 2 M4 screws and T Nuts.

I did design another holder that did not require screws but slid into the frame slots, however this could only be used at the back as it would require removing the mother board holder on the Aquila. If others are interested in this I could post as a separate design.

Print Settings

Printer:

Aquila (Ender 3)

Rafts:

No

Supports:

Yes

Resolution:

0.3mm

Infill:

30%

Filament:

Any

Notes:

I printed this upright (as shown in picture) with auto supports, overhang set to 60% so supports were only created for the screw holes. No supports were required for the rest of the holder.

How I Designed This

Web cam holder designed in Blender.