Voron AFTERBURNER Clockwork 1 to PANDA MINI

Print this part as replacement main body for a Voron Afterburner extruder, in heat resistant filamant. I believe the original extruder is a Clockwork “1”

I used PC, but ABS would be great. There are three holes in a triangle formation on the bottom. Add M3 heat inserts to the outer holes. Build Voron Afterburner extruder as per Voron instructions. Screw it onto Panda Mini hotend mount with M3 X 8mm screws. 

You will probably need a short length of PTFE tubing, say 19mm, to bridge the gap between the extruder and the hotend (again as per Voron guidelines)

When I tried assembling the extruder I found that the motor plate fouled the toolhead mount, so the revised MOTOR MOUNT shaves a bit off the bottom to provide a better fit