Ski Rack - No supports!

A simple Ski Rack with different sizes provided.
24
150
0
758
updated May 28, 2024

Description

PDF

I made this simple model of a Ski Rack. The intended use is to hang skis simple and quick on the wall of a house/cabin/shed (or whatever). The rack is screwed to the wall, and the skis hang from the ski tips. Simple and easy! 

Prints without support!

Lay the model flat (as shown in the picture) to have the layers in correct orientation for strength. Use a lot of walls! (minimum 8-10).

Those shown in the picture will be covered by a door, so they wont be in the sun. Therefore I printed them in PLA. You choose material according to where they will be used. For outdoor use ASA might be a good choice. 

I have made 3 different models, each with different distance between the bars. 10mm, 15mm and 20mm width. 

10mm width for cross country skis

15mm width for down hill skis

20mm I added for good measure :)

 

EDIT: By request, I added an extra wide version with 50mm between the bars.

 

 

There is also a width tester for each size, so you can easily print this tester, with minimal use of filament, to check what size is correct for your skis. 

 

Tags



Model origin

The author marked this model as their own original creation.

License