My first upload.
My first upload. I printed mine with supports, but you could try without to see if you can cut down on print time.
Printer Brand:
Creality
Printer:
Ender-3 S1
Rafts:
No
Supports:
Yes
Infill:
Gyroid
Filament:
Microcenter - Inland PLA Tough
black
Notes:
Two versions, one without rubber feet holes, and one with. The one with rubber feet holes still has a pocket on the bottom for a magnet, but my printer filled the pocket with support material.
The hot-glue in the picture is from an attempt at gluing two magnets on the bottom of the one with holes for the rubber feet.
Just something to keep working on.
Category: Other
The author marked this model as their own original creation. Imported from Thingiverse.
