Seed starter for peat pellets using biodegradable PLA filament

This peat pellet holder is easy to print, and utilizes a slab modifier to create a honeycombed pattern throughout the unit.    Printed using PLA “biodegradable" filament (https://www.amazon.com/dp/B0853468ZF) with 10% honeycomb fill density and a slab that modifies the model so that there is 0 bottom, 0 perimeters and 0 top.  

Once printed, place peat pellets (https://www.amazon.com/gp/product/B0097W9U76) into holders, spray over time with warm water to moisten until about 30 mm tall, and plant your seeds.  Care for them until the sprouts are mature.  Then, easily pull off the meshing (or pull out the pellets) and transplant into your garden.