Wanted a more secure way to mount my HL-X pressure pad tape switch to an M-LOK rail. The adapter uses 2 standard M-LOK bolts and the mounting screws that come with the HL-X light itself.
First install the adapter to the M-LOK rail at the desired position. The adapter can be mounted in half slots as well. Route the wire through the appropriate channel to take care of the slack in the cable before screwing the switch on top.
NOTE: The screws that come with the HL-X are about 2 mm too long so depending on where you mount the adapter, you may need to shorten the screws an appropriate amount to not interfere with the rail.
Print in PETG or something durable.
I've had good luck with 100% infill. Supports needed.
The author marked this model as their own original creation.