This is a way to mount MGN-7 linear rails on European style 2020 extrusion since MGN7 fits so nicely in EU style - it's like they were made for each other! It's extremely snug and I can't get it to move a tenth of a millimeter by hand once things are tightened down. Doesn't require stripping the plastic to get it tight enough - I only had half the screws in and it was ridiculously stiff.
MGN7 rails require M2x6 screws, so I created this since m2 hammer nuts don't seem to exist. Ended up working way better than I expected.
Print with the small side on the plate. I'm sure it would work fine the other way too if you can't get it to print right, but you'll have to lower it past the plate so it doesn't try to bridge.
The author marked this model as their own original creation.