Ikea Skadis Narrow Screwdriver Mount

I loved the original model but the screwdrivers would sometimes lift the print from the Skadis pegboard. After lifting from the Skadis I would of course go to push the holder back in and then the hook would snap off.

This remix uses the t-nuts found here: https://www.printables.com/model/228663-skadis-t-nuts-mounting-system-for-ikea-skadis-pegb

I used a M2 x 12mm screw to mount the t-nut.

I recommend using the pre-sliced g-code (which is PLA) unless you feel like adding negative spaces yourself.

The original utilized a hook to mount to the Ikea brand Skadis pegboard. This design utilizes a t-nut screw to lock down to the same pegboard.