Lamona Electric Oven Knob

Designed using Fusion 360 to replace the original because, the original split down the shaft.
There were a few prototypes to ensure that I got the hole just right to slide on the switch, with just the right amount of tolerance.

Print instructions

Licence: Creative Commons - Attribution - Non-Commercial - Share Alike Category: Kitchen & Dining Print Settings

Printer: Original Prusa i3 MK2

Rafts: No

Supports: No

Resolution: 0.2

Infill: 25%

Notes:

Sliced with Simplify 3D
Speed 50 mm/s
Hotend 210
Heatbed 55