Night of the Souls | 2 or 6 parts

This is clearly outside my comfort zone, but i wanted something with red for my living room.  Still not big enough but i like it :)

I hope you like and feel free to make comments/suggestions.

Expect some loooong prints using 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

Filaments Used:

• PLA Overture Black
• PLA+ Esun Dark Blue
• PLA Overture Wine or PLA Ziro Red
• PLA Overture Red
• PLA Overture Jeans Red
• PLA BambuLab Basic Orange
• PLA+ Sunlu Pure Yellow
• PLA+ Sunlu White

Swap Instructions:

• Start with Black
• At layer #7 (0.64mm) swap to Dark Blue
• At layer #9 (0.8mm) swap to Wine or Ziro Red
• At layer #19 (1.6mm) swap to Overture Red
• At layer #22 (1.84mm) swap to Jeans Red
• At layer #24 (2mm) swap to Orange
• At layer #28 (2.32mm) swap to Pure Yellow
• At layer #30 (2.48mm) swap to White for the rest.