Corner Clamp

I needed a set of clamps for a woodworking project. I used ¼ inch hex bolt of about 3.5 inch long and a corresponding ¼ inch nut. 

The bolt fits inside the “grip 2 A” object. And the “grip 2 B” object can be used to cover the bolt. The nut fits in the “camp out” object.

The "clamp b" object should be printed upside down. And it has a space to insert a small coin so the bolt touches the coin rather than the plastic. By stopping the print at 23mm hight you should be able to insert the coin and continue printing afterward. 

Printed in PLA at a 0.3mm layer hight. 

Update, I added a version of the clamps with some space at the corner for the glue to scape or being wiped off.