Adjustable, Vertical Laptop Stand

Adjustable stand to hold laptops in vertical position for storage or use with a separate monitor.  

Build Info:

PLA

0.3 layer height

2 perimeters / 30% In-fill/no supports

Note: on 11/13/23 I added an additional file for the feet with the retention retention features removed.  Those features lock the stationary jaw in place and prevent the movable jaw from coming off the stand if the hasps aren't installed.  If you find it too difficult to snap the jaws on the frame, the new file can be used.

The original required a different file for each size laptop used.  This design is adustable to accommodate laptop and tablets the range between 10 and 40+ mm, exceeding the range of the original.  The design addresses some of the comments for improvements listed under the original, non-adjustable design.