Prusa Mini 90deg heatbed cable cover

This mod turns the Prusa MINI heatbed cable bundle 90deg to save some real estate in y direction. Now I can put the printer closer to the wall. The top part is 0.5mm taller than the original, it shouldn't pose any problem. In case it does, try adjusting the nozzle height or the PINDA probe height a little bit. Rewire the heatbed cable as shown in my photo, make sure you are not shorting out anything. You'll probably need to trim off some of the nylon sleeve.

Print with PETG, ASA or other more heat resistant material (I used carbon fiber nylon). And use more perimeters than usual (I used 4) to stiffen the dove tail. No support required.