.300 Norma Magnum case

I got a request for a .300 Norma Magnum ammo 10pcs case.                                                     The spacing is 10pcs/14,9x91,5mm. The shell was so close to the .338 i made before so i used that as template and just made the bullet 1,5mm longer. I wanted to use the latches i have on the other ones even it's much thinner case. So i made the tiniest box i ever made to see if it works. It works just fine but you have to use ABS or similar to the latch and latch cam. I have not printed the hole case just the small one but it very similar to my other cases so it should work just fine and i hope Kirk who requested it can tell us later. I'm using 1,6mm stainless Tig-welding pin to both the hinge and latch.

Hope you like it.

A remix of the Latch and Latch_cam