Hexalight - exagonal nanoleaf replica no soldering & support

This is an original artwork that takes inspiration from nanoleaf projects.

My twins loved Hexagonal-Alexa enabled - light so I elaborated this model in thinkercad and prepared with several trials&errors

About the model itself:

@ it has 2 passages on each side for led strip setting but also for heat dissipation

@ you can combine as much hexagons as you want

@ fixing hangs are provided in order to lock hexagons each other

@ use one (or more) of the holes present in each angle for hang the light

@ any lightstrip will be fine but the thinner and power saving & cool ones are recommended  the best it is. Lightstrip may be glued on internal perimeter of Hexagons

One exagon need 2 hours and 38 min at 0.3 mm while for a couple of hangs at 0.2 mm it takes about 12 minutes. Print on metal sheet in order to get better results.

REMEMBER TO READ THE DISCLAIMER: this is a work in progress . Keep controlled lamps , leds and whatever you connect to electrical power as all this stuff  may in certain conditions leading even to fire ignition or electrical shock . I'm not responsible for any possible damage, use at your own risk.