60deg Angled, Tall Prusa MK52 Heated Bed Cover (for Thicker Cables/Terminals)

Designed specifically in cases where your cable connections to your MK52 heated bed is tall - in my case due to a combination of using a slightly thicker cable and using ring terminals with a really thick insulation layer.

This cover is designed with a height gap between the bed and the ceiling of the cover itself being 8mm tall (vs the usual ~3mm gap in original heat bed cover). Do take a measurement after you dry fit your heated bed connectors before your decide to print this and determine that it suits your need.

Other parts that you need:

• M3 hex nut
• M3 15mm mechanical screw
• 1 2-3mm zip tie that is at least 10cm long (I personally use a 15cm one and cut off the excess)

Print with the top of the cover facing down towards the bed.