Desk Organizer with Drawers

This was designed for our Travel Trailer table, to hold the sundry items we use every day like pencils, flashlights, tooth-floss and vitamin containers - but could be used for anything.

At .3mm Layer heights on a MK3s it was just under 40-hours of printing and 1kg of filament.

With PLA, I had to lower the fan-speed to avoid thermal run-aways on the long flat areas, something to keep in mind.

I would recommend mouse-ears on the corners of the case - there's not a lot of room for a brim, so you'll have to add the manually. I printed the case vertically and got some lifting at the corners, but it was already 10 or 12-hours in, so I left it. It's fine, but obviously perfectly flat would have been better. 

Printed in Overture Rock Matte PLA

If you decide to print this or any of my designs, please post a make - that's the best compliment you can offer!

Or Buy me a Beer!