Super Lightweight Sailplane Glider Hexe

Lightweight hand throw glider Hexe.
Super quick print, bed level test and fun sail plane to fly indoors on windy days or on calm days as a small hang glider.

Print body and vertical stabilizer seperately and stick the stabilizer into the slot at the end of tje body. Should hold, if not give it a drop of superglue.

Bend the tail slightly upwards directly behind the wings.

Grab between wings and stabilizer and throw gently.

Print with 0.1mm layer height or below. 0.06mm layer height is best. Finer layer height gives better wing profile.

100% infill.