TV Remote Control Command Station (Holds 3 remotes)

I've got two young kids and hunting for remote controls was a constant source of frustration. I figured out that if you group the remotes all in one place, they're larger so you spot them easier, and if you found one, you found them all.

heavy-duty

I used heavy duty velcro tape in two pieces on the back of each remote to attach it to the plate. This allows re-arranging the remotes and replacing batteries. The hex pattern I added for aesthetics, but it turns out they're a good size to put my fingers in.

There are many remote control holding solutions, but this one is mine. 

I printed 0.2mm layer height. The finish is nice since it's in my hand a lot. You could print faster at 0.3 if you wanted to make it go faster.