Toothbrush Holder for small family

Toothbrush holder designed to hold 2 electric toothbrushes (30mm and 35mm holes), one regular toothbrush (20mm hole), three different toothpastes (2x43mm and one 30mm hole), plus two smaller holes for whatever else comes up.

Model is intended to be printed on its side. Supports can be used to improve the final aesthetic of the model, but aren't required.

Two different designs are included here - the only change being the cut-outs on the curved section. This will use less filament, but take slightly longer to print.

Design is inspired by the Bathroom Arranger, by @Elsa, but designed from scratch based on my own needs.

Remix has been remodelled from the ground up, but based on the look/design of this model.