Flashlight Diffuser for Streamlight ProTac HL-X

Flashlight Diffuser for Streamlight ProTac HL-X

Settings

• Surface Mode: Surface (no top or bottom) OR Both (be sure to flip the model 180 so the top will be printed and the bottom will be open)
  • I recommend rotating the model 180 to print the top fully (it should print like an ice cream cone)
• Spiralize Outer contour (vase mode) 
• Layer Height: 0.2
• Wall width: 0.82

With these settings my print was snug on the crown of the flashlight and created a good seal. It “pops” when detaching it from the flashlight. You might need to adjust your wall width depending on your printer to get a good fit.