String Art Torture Test: Great for Calibration

3D print this string art torture test for your 3D printer to make sure it is greatly calibrated!!! This model will make sure your 3D printer can print mid-air bridges, a key for successful string-art prints!!!

PRO TIP: DO NOT ENABLE RETRACTIONS!!! THAT WILL RUIN THE BRIDGING!!!

Supports: No

Be sure to select “print thin walls” or set wall generator to “Arachne”

This is the bottom layer of the Model: “Suspended Hand” by STomHacks. I excluded the “hand” part, making the test quite hard. This test is great for general calibration, since many intricate models incorporate string art.