Voron Mini Stealthburner LGX Lite + PCB Klicky Mod

This modification for the Voron Mini Stealthburner involves replacing the original extruder mechanism with a mount for the Bondtech LGX Lite extruder. Additionally, one of the side cowlings has been adapted to accommodate a Klicky PCB probe. This placement of the probe allows for a full range of motion and maintains nearly the same part cooling airflow. For this setup, I use the KlickSwipe Vertical+Klicky PCB Mod – a servo-controlled sensor dock. This is because the original horizontal dock encounters space limitations when used with this specific toolhead modification.

The XY nozzle of the probe is designed to be as compact as possible. However, it was necessary to move it 6 mm forward to avoid collisions with the lower right XY joint. We aimed to minimize the Z offset to keep the magnets as far from the bed as possible. Due to the compact design of the Voron 0, some compromises had to be made. The actual offset varies depending on several factors, but for the Revo, it is calculated to be 12 mm. As is typical with FDM printed assemblies, it's advisable to recalibrate after the first few prints.

[probe]
x_offset: 27
y_offset: -6
z_offset = 12.00

The length of the PTFE tube between the extruder and hotend varies depending on the hotend model. For the Revo Voron, it appears to be 30.20 mm. Please cut a slightly longer piece initially, then test fit and gradually trim it until it reaches the exact required length.

You also need to update the [screws_tilt_adjust] section, and optionally the [bed_mesh] configuration sections as well. For example:

[screws_tilt_adjust]
screw1: 85,106                # 112-27, 112-6
screw1_name: back right
screw2: 0,106                 # 8+27.07, 122-6
screw2_name: back left
screw3: 33,14                 # 60-27.07, 8+6
screw3_name: front screw
horizontal_move_z: 20
speed: 150
screw_thread: CW-M3



[bed_mesh]
mesh_min: 28,8
mesh_max: 112,112
speed: 150
horizontal_move_z: 20
probe_count: 3,3#if you would like more detail, use 5,5 here
move_check_distance: 3

algorithm: lagrange
fade_start: 1
fade_end: 10
fade_target: 0
split_delta_z: 0.0125
mesh_pps: 2,2

Replaced the extruder part with a mounting point for LGX Lite extruder. Added a Klicky PCB mount point.