The "NicoJ Flip" Eleven Table Tennis adapter for Meta Quest 3

Advantages over the previous one:

- lighter (46 g with screws, depending on print settings...)
- lower center of gravity (less head weight)
- the position of the controller's top plane is respected in relation to the hand-held position, which should improve tracking

Print:

All parts have to be printed. Print two handles and two thumbscrews.

Two different handles are provided, large and small, print the size you prefer (print twice the chosen stl).
Only handles need to be printed with support (supports are easy to remove).

To improve weight, you can use low infill values, and just increase the values near the parts with around the screws. You can also reduce top and bottom layers, or wall numbers on handles for instance.

Then you need two M4 screws and their nuts. Ideally, one 16mm and one 24mm screw, but larger sizes work.

Installation:

To install the controller, slide it from top to bottom in the upper left-hand section (this section can remain on the racket), then close it with the right-hand section and fit the two screws. Installation takes no more than 30 seconds with a little practice.

Two orientations of the controller are provided for the Left And Right Parts (you can choose the one you prefer).

You can use the settings for the two orientations

235063.3 in ElevenVR for the side orientation.
235063.5 for the down orientation

To choose setting -> Go to “Gears”, “Carrot, “Backup And Reset”, and then “Download” with the key.

Print Settings

• Printer brand:

Wanhao

• Printer:

Duplicator 12

• Rafts:

No

• Supports:

Yes

• Notes:

Supports are needed to print handles (flat printing them is better for strength)