Egg Lamp Shade

This is a lamp that I printed a few years back and its just held up so well. I actually printed a few different types and all have held up great. I used Glow in the Dark filament so if the power goes out it will hold a little glow for a little bit. It was printed from PLA. But the wire holder was done in PETG to handle better heat.

Enjoy

Sherm

Other designs:

https://www.printables.com/@shermluge_65353/models

https://www.thingiverse.com/shermluge/designs

https://cults3d.com/en/users/shermluge/3d-models