RSP1 6-port Clone Slide-in Case

The case was designed to be simple and a one-piece design. Other cases were for other numbers of inputs/other versions of the design, or in the case of the one project that did exist for the 6 input version, a two-piece design. This design was loosely based on a similar idea for the 5 input version.

The grooves inside should grip your board sufficiently, but obviously your printer setup may end up changing how tight the fit is. There is absolutely no grip on the sockets, so the grooves need to do the work. Because of this you may want to put nuts over the sockets to help, hopefully two will exist side by side. Or blu tack the back :)

Very little infill, so it doesn't really matter what you use in my experience. This worked after 3 revisions and is my first ever project that I'm sharing, so go easy on me.

FreeCAD, tested on an Ender 3 V2 Neo.