The cable holder of the D850 in particular tends to break off in the heat of the moment. This file can be used to remedy the situation. It is not the entire cable clip, but only the small cable holder as a spare part. It is a slightly simpler shape than the original.
Required build volume: 35 mm x 17 mm x 20 mm
Material consumption: 2g
Material: the best material to use is a hard plastic. I used ABS from Fiberlogy.
Support: not mandatory, depends on the printer.
Nozzle size: 0.4 mm
Print quality: 0.12 mm
Filling: 100%
Printing plate adhesion: not mandatory, depends on printer
The author marked this model as their own original creation.
