Enclosure for Wuzhi Audio ZK-3002 TPA3255 Digital Amplifier Board Stereo 300W x2 Bridged Mono 600W

No screws required, 2 clamps are used instead to hold the 2 enclosure parts together and also serve as feet.

Steps to assemble:

1. Place the board into the bottom of the enclosure.
2. Place the top of the enclosure over the bottom one.
3. Slightly stretch the clamp to go over the top, slide it all the way down through the guides until it closes under the bottom case part. Repeat for the second clamp.

Tip: Right after the clamps finished printing, remove them from the print bed and keep them in your hand slightly tensioned inwards for a minute or so. This way they will cool down in a slightly more closed position, thus keeping the tension after mounting them over the case.

No supports required if printing in orientation shown in the attached slicer screenshot.

The front panel is not customized, that depends on your input connector type and on your volume potentiometer type: you can either simply drill holes or import the STL in ThinkerCad and place some holes, then export and print.