Valve Index Lighthouse full-sized wall mount

Use whatever screws you used for the original mount from Valve.

I printed this on an Ankermake M5 in Fast mode with Supports and with a layer height of 0.25mm. It has enough clearance to work without doctoring around with it after print while still giving the base station a good solid fit. 

As recommended by the original author, 2 flathead screws (max 4.5mm for screw diameter and 9mm for the screw head diameter) are possible.

Increased the height of the mount to match the height of the official mount (plus margins…). That also allowed me to move the holes to the same distance as in the official mount, allowing you to use the same holes you already got in your wall when you want to start using this quick swap mount.

Somehow coincidence led to the holes being EXACTLY underneath the original holes when you slide in the original mount into this quick swap mount… but that has no down or upsides