The Screen Thing - A Screen Holder to Make Your DM Screen Stand Up Perfectly!

WHAT IS IT?

I don't know what to call it, that's why it's called “The Screen Thing!” It's a little bracket that holds your DM screen at a perfect angle so it can't flop around. Print enough of these to fit all the bends in your DM screen, slip them on, and your table will look a lot neater!

There's a 2.5mm gap for the screen to snugly fit inside. If your screen is significantly thicker or thinner than that, I suggest you scale this model in your slicer!

NO ADDITIONAL HARDWARE NEEDED

MY PRINT SETTINGS

This little guy can be printed just about however you like. I printed mine at 20% infill at 3 walls. If your screen is super thick or super thin, you may want to scale the model up or down in your slicer.

…why yes, I did just lay a cheap TV on my dining room table to play D&D…