VanMoof X3/S3 kick lock cap

This is a kick lock cap for the VanMoof, to avoid triggering the lock when the bike is stored indoors or is in for a repair. The cap is a friction fit and simply clips over the lock. The cap has been tested on both an X3 and S3. The fit is quite tight to ensure it doesn't drop off – it went on a half hour bike ride without falling off. It's probably best printed in PETG to give some flexibility, but PLA should also work thanks to the thinner design of the clip-over part.

You need to print this part with support. Support is only needed for the bottom half (see included screenshot).