Sunlu S1 Filament dryer mount for RepRack

Sunlu S1 drybox holder for the Rep Rack system.   

Uses 4 M3 bolts to hold the sides together, the hole goes all the way through so anything 10mm-45mm should work fine.  The hole is sized to allow the M3 to self tap, at least on my printers it is :)  There is a left and right side with a champers to accommodate countersink screws. other than that, they are identical.

You will need about 11 inches of clearance from your RepRack bars to be able to install and remove the S1 

I was able to print this on a 300x300 bed with no issues, I'm not sure it will fit on a 240x240.  I may revise without the filament guide if there is enough request for it.

I've been modeling my own parts for a few years now and this is the first one I have shared with the public, I would appreciate any feedback and pictures of your use of this model.

Thanks to Dion Christensen for the great S1 model, saved me A LOT of time.  https://www.printables.com/model/237655-sunlu-s1-filament-dryer

And a huge thank you to Repkord for the awesome RepRack system. https://www.printables.com/model/129024-reprack-open-source-spool-holder-and-storage-syste

Note: I do not have the decorative covers on my bars, so I'm not sure this will fit on the covers.