Ender 3 V3 SE magnetic reverse Bowden adapter

Ender 3 V3 SE magnetic reverse Bowden adapter.

Requires:

• 1 - PC4-M10 Racor fitting
• 2 - 3/8 x 3/8 N52 magnets

Instructions:

1. Print 1 of each part (oriented parts 1 & 2 so the magnet holes are facing up)
   • 20% infill
   • cubic infill
   • 0.12 mm layer height
2. Press magnetics into magnet holes
3. Screw PC4-M10 into part 2
4. Press part 3 (pin) into part 2
   • Depending on your printer's tolerance, you may have to sand the pin (should press fit)
5. Sand the exposed pin to fit into part 1
   • The fit should be snug, but not binding